HIPERTOUCH Reflex: “Purchased my Reflex and installed into my Sig 716 and there is no comparison between the stock mil-spec trigger and the new Hiperfire trigger, VERY smooth, breaks light and crisp, I am using the 3-1/2lb spring set up, and am thoroughly happy. Am going to order extra springs for later just in case of losing while cleaning or just being worn out from shooting so much, cuz I like it so much… Also, was my first time to switch out a trigger set-up on an AR style rifle, hardest part was getting the grip off to take the safety out to get the old trigger out and install the new one, as it does sit below the safety. Total of about 25 minutes for a first timer and worth every minute.”

HIPERTOUCH Elite: “I just installed a Hyperfire Elite trigger in my AR-10. My goal was to cure some fail to fire issues due to light primer strikes using some foreign military surplus ammo. I have only installed an AR trigger once before and was thinking the Hyperfire trigger could be a problem for me to install. It was way easier than I thought. I did learn one trick to pass along. The trigger and hammer installation is very straight forward. Compressing the coil springs looked like a problem area. I used a 5/32 inch pin punch (flat working end) and cupped my free hand over the spring assembly to prevent lost springs. Success on the first attempt with no flying parts. The trick is to position the yoke just above the notch where it will rest. Push straight in and slightly downward and it falls right into place. The difference between the Elite trigger and military stock trigger is amazing.”