HIPERTOUCH® Elite

HIPERTOUCH Elite: “I installed the Elite trigger my friend obtained from you at the SHOT Show in my S&W 15-22 and shot a tactical 22 match with it today.  To say that I love this trigger would be an understatement.  I have tried other custom triggers in this rifle and have found that I need to go up to a 3 1/2 – 4lb. trigger pull to have enough hammer spring tension to reliably fire 22LR’s .  Even with the lightest springs installed, your trigger was 100% reliable.  The Elite does have some take up, but it only took a few rounds to get used to it. I want to thank you inventing this trigger, since it is the ideal set up for 22LR’s, or other calibers that may have reliability problems due to hard primers.”

HIPERTOUCH Elite: “I just installed a Hyperfire Elite trigger in my AR-10. My goal was to cure some fail to fire issues due to light primer strikes using some foreign military surplus ammo. I have only installed an AR trigger once before and was thinking the Hyperfire trigger could be a problem for me to install. It was way easier than I thought. I did learn one trick to pass along. The trigger and hammer installation is very straight forward. Compressing the coil springs looked like a problem area. I used a 5/32 inch pin punch (flat working end) and cupped my free hand over the spring assembly to prevent lost springs. Success on the first attempt with no flying parts. The trick is to position the yoke just above the notch where it will rest. Push straight in and slightly downward and it falls right into place. The difference between the Elite trigger and military stock trigger is amazing.”