American flag
Veteran Operated MADE IN THE USA

SALES & SUPPORT (651) 762-2800 M-F 7:00AM-4:00PM CST

The trigger pin walks out. Can it be fixed?

April 27, 2015

The trigger pin walks out because it is not captured by one of the hammer spring legs. This can happen in two ways and yes, it can be fixed.

  1. The hammer spring’s legs don’t seat in the slot made for them on either side of the toggle FRAME so they can’t rest in one of the trigger pin’s grooves and retain it. Fix this by making sure they do. If that doesn’t work, read on.
  2. The TRIGGER SLEEVE has not been rotated so that its notches match or line up with the notches on either side of the FRAME (this was noted in the installation manual and in the online installation videos). To fix that, take out the trigger subassembly and inspect it. If the SLEEVE is out of alignment, squeeze down on the disconnetor to release some clamping pressure on the TRIGGER SLEEVE and rotate the SLEEVE with a tool or your finger nail until alignment has been established. Now the hammer spring legs can lie in the trigger groove to keep it from walking out.

Related Articles

Only show articles for the following products:
Only show articles for the following products:
Only show articles for the following products:
Only show articles for the following products:

Join The Movement

Follow us